Lakeside Drive

I use the 4 button Philips hue dimmers. Mostly mostly because I already had some from before I started using home assistant, and then because it’s easier to add more or replace when needed. All reconfigured in node-red, all behave the same:

• quick press of the on button toggles the room’s ceiling lights
• quick press of the up button toggles the room’s lamps
• quick press of the down button toggles the room’s fans
• quick press of the off button turns everything in the room off
• long press of the on button toggles the room’s curtains
• long press of the up button brightens any lights that are on in the room
• long press of the down button dims any lights that are on in the room
• long press of the off button turns off all downstairs devices and locks the doors

All my printing is done at my local makerspace. We have:

3 x Ultimaker 2

3 x Ultimaker 2 extended

Formlabs Form 3b

Markforged mkII

Most of my printing is in the Ultimakers but I use the form 3b for anything small or that needs that extra find detail. I havent found a good reason to use the Markforged yet (the consumables are quite expensive) but should be fun when the need arises :)