I have a Ryzen 5 1600AF (Zen+) and 2x 8 GB DDR4 3600 HyperX. when I select XMP1, it says 1.35V in the profile. however, when I boot Strelec WinPE USB (I’m on Fedora, I really don’t want to install windows just so I can run HWINFO), install all drivers and launch HWINFO64 it says 1.2V. so I enter BIOS again, go to Voltages and enter 1.35 manually instead of auto. no change, still reads 1.2V. the BIOS side screen shows 1.35 after reboot.

I’ve found an unresolved thread somewhere with the same problem for my board. I’m on latest BIOS.

am I missing something, is there some additional setting I need to switch so it registers? the BIOS setup is hella confusing and borderline stupid, e.g. enabling virtualization required turning on SMP (how am I supposed to guess what that is?!) that’s located in the “Frequency” subsection (wtf?!).

  • dingdongitsabear@lemmy.mlOP
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    correct, HWINFO64 lists two. thanks for the link, but seems way too cumbersome to install it so I’ll use WinPE from my Ventoy USB drive if I need to check if the detected voltage changes.

    • SteveTech@programming.dev
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      Yeah it does need a sensors config for your motherboard too, if you want the proper names, but I won’t be able to get mine until maybe Sunday.

      • dingdongitsabear@lemmy.mlOP
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        I’m mainly checking if there’s something else to switch in BIOS or that’s all there is to it and my setup is just incompatible; I’m waiting to snag a used 5600 when they drop a bit more in price, since they’re supposed to work better with faster RAM. but sure, if you get around to it I’d appreciate any config you can share.

          • dingdongitsabear@lemmy.mlOP
            link
            fedilink
            English
            arrow-up
            1
            ·
            1 year ago

            my original reply vanished, so here I go again: thank you very much for your efforts and for following up. I couldn’t get the driver to compile on my system but that wasn’t my primary goal, guess my setup is just incompatible. hopefully I’ll get a used 5600 by year’s end and check then. thanks again.

            • SteveTech@programming.dev
              link
              fedilink
              English
              arrow-up
              1
              ·
              edit-2
              1 year ago

              No worries!

              I believe for the driver you need to install build-essential @development-tools (forgot about fedora) and then run sudo make dkms.